AMR stands for Automated Meter Reading. The AMR reads all meters in its network, in one place and in a short time. All the readings can be transfered to a pen drive, SD card or other devices via infra red and Bluetooth. It also can transfer all data through SMS and GPRS.

A system that uses solar energy as power to operate the gate operations.

The Early Alert And Warning System is used to monitor the pump system and panel to ensure the sewage system running smoothly. Besides that, the system also monitors the security at the site, where it was installed in terms of opening/closing a door, motion detector and on/off power. The system will send sms of the real-time condition of the site, where it was installed directly to designated persons. The statuses of its sms are ‘Trip’, ‘Run’ and ‘Repair’.

Dual Tone siren also helps in flood mitigation studies.

The Prepaid Management System used SMS-Based communications for all its real-time transactions & monitoring. Remote payment can be utilized by using this system. Performance of the system is as below:-

• Generate prepaid card for consumer and cards for management
• Allow consumer to top up and check balance of the card
• Transmit emergency messages & trigger alarm on unauthorized entries
• Download & update transaction information and generate reports
•  It uses the smart card as a prepaid card

Open channel flow meter is one of our products that were used to monitor and supervise hydrological data. It is used to measure the flow of liquids that are open to the atmosphere at the some point in the measurement system. It provides real-time data monitoring, parameter alerts and remote status interrogation for all connecting RTUs. It also helps in flood mitigation studies.

Monitoring and supervising of Meteorological data such as Rainfall, Air Temperature, Relative Humidity, Solar radiation. Provide real-time data monitoring, parameter  alerts and remote interrogation for connecting RTU’s status. Fully back up data can be manually collected with flexible intervals.

Pump automation is made possible by RTU remote feedback and triggering of volt –free control signals to main pump switch control panel. Remote monitoring provides pump status to be immediately transmitted to Control Centre and operator mobile phone using pure SMS text message. Pump operation data can be logged into computer database system by MySMS data downloading.

Telemetry system really helps in reservoir’s water level monitoring and water management work. RTU will be placed on top of the reservoir and powered by solar energy. Linking the RTU to pumping station RTU will automate pumping frequency in timely manner. Insufficient or loss of water situations can be minimized with full alert notification feature during low or high water level. MyTeleLogger can be configured to monitor other parameters such as pressure, flow rate and water quality measurement.

Tidal Gate automation will provide timely gate opening and closing. Apart from that, AC input, river water level, tidal level, gate positioning and battery voltage can be monitored remotely. It combines expandable PLC I/O board and MyTeleLogger controller, to form a complete system. Gate operators work can be simplified and ultimately gear  towards unmanned system. Master computer system registers and logs all gate operation using SMS transmission.